SCALP VERNAEAU PU 16

Clear waterborne polyurethane varnish

READY FOR USE (Glossy or mat)

Two component clear waterborne varnish. It is a permanent protection against graffiti which resists to graffiti cleaner, effective over thick coatings, paints, stone, cement, delicate substrates.

I- PROPERTIES

SCALP VERNAEAU PU 16 is clear waterborne polyurethane varnish.. It is designed to protect surfaces which are sensitive to solvent such as for example paint, thick façade coating, PVC cabinets, road panels, and enable cleaning them when spoiled with graffiti.

After polymerisation, film formed by SCALP VERNAEAU PU 16 resists to many rubs with SCALP ANTI GRAFFITI 49 or to stripping with SCALPEX AL

SCALP VERNAEAU PU 16 is a waterborne dispersion and display in deliver form a milky aspect, but it becomes clear after drying and polymerisation.

The film resist well to outside weathering, it is micro-porous and let the substrate breath. It is not saponifiable and resist to pH variation from substrate.

SCALP VERNAEAU PU 16 can be used both inside or outside.

II- CHARACTERISTICS

Visual aspect: milky liquid

Specific gravity: 1.06 g/cm³ at 20_C

Cleaner: solvent

Pot life: 3 hours

Drying time: 8 hours at 20_C

Recoating: after 1 hour

Sensitive to freezing

Efficiency: 150 to 200 g/m²

Ambient application temperature : 5 to 50 _C

III- INSTRUCTIONS FOR USE

Pour the hardener into the resin bucket, stir well for 5 minutes. SCALP VERNAEAU PU 16 is ready to use when blend is achieved, and must be used within 3 hours.

Apply SCALP VERNAEAU PU 16 with a brush or roller, avoid local excess or sagging.

Let dry for 1 hour only, then apply a second coat: it must be noticed that in order to obtain good adhesion between the 2 coats, the first coat must be recoated before it is completely dried and polymerised.

SCALP VERNAEAU PU 16 will exhibit actual protection against Graffiti after 3 days of further drying. The SCALP VERNAEAU PU 16 film provides a wet appearance over porous surface such as stone, marble, when use as alone. It is recommended to apply first Scalp primer 36 as undercoat.

Tools must be cleaned with water immediately after use.